ISFST2002 Publications Format Hideo Nakano Osaka City University, Media Center 3-3-138 Sugimoto, Sumiyoshi-ku, Osaka 558-8585, JAPAN nakano@media.osaka-cu.ac.jp ABSTRACT In this paper, we describe the formatting requirements for ISFST2002 Keywords Guides, instructions, conference publications INTRODUCTION The ISFST2002 Proceedings is the records of the conference. As in previous years, we hope to give the books a single, high-quality appearance. To do this, we ask that authors follow some simple guidelines. PAGE SIZE All material on each page should fit within a rectangle of 17.8 x 23.5 cm (7" x 9.25"), centered on the page, beginning 1.9 cm (.75") from the top of the page, with a .8 cm (.3") space between two 8.5 cm (3.35") columns. LENGTH OF PAGES The length of the paper must be within 6 pages for a full paper and 3 pages for a short paper. TYPESET TEXT Prepare your submissions on a typesetter or word processor. Normal or Body Text Please use a 10-point Times Roman font, or other Roman font with serifs, as close as possible in appearance to Times Roman in which these guidelines have been set. The goal is to have a 10-point text. Title and Authors The title (Helvetica 18-point bold), authors' names (Times Roman 12-point bold) and affiliations (Times Roman 12-point) run across the full width of the page - one column 17.8 cm (7") wide. We also recommend phone number and e-mail address. See the top of this page for two names with different addresses. If only one address is needed, center all address text. For two addresses, use two centered tabs, and so on. For more than three authors, you may have to improvise. Abstract and Keywords Every submission should begin with an abstract of about 100 words, followed by a set of keywords. The abstract and keywords should be placed in the left column of the first page under the left half of the title. The abstract should be a concise statement of the problem, approach, findings, and conclusions of the work described. Subsequent Pages For pages other than the first page, start at the top of the page, and continue in double-column format. Right margins should be justified, not ragged. The two columns on the last page should be of equal length. References and Citations Use the standard Communications of the ACM format for references - that is, a numbered list at the end of the article, ordered alphabetically by first author, and referenced by numbers in brackets [1]. See the examples of citations at the end of this document. Within this template file, use the style named references for the text of your citation. References should be published materials accessible to the public. Internal technical reports may be cited only if they are easily accessible (i.e. you can give the address to obtain the report within your citation) and may be obtained by any reader. Proprietary information may not be cited. Private communications should be acknowledged, not referenced (e.g., "[Robertson, personal communication]"). Page Numbering, Headers and Footers Do not include headers, footers or page numbers in your submission. These will be added when the publications are assembled. Put page numbes by a pencil on the reverse side of manuscript. SECTIONS The heading of a section should be in Helvetica 9-point bold in all-capitals. Sections should be unnumbered. Subsections The heading of subsections should be in Helvetica 9-point bold with only the initial letters capitalized. (Note: For sub-sections and subsubsections, a word like the or a is not capitalized unless it is the first word of the header Subsubsections The heading for subsubsections should be in Helvetica 9-point italic with initial letters capitalized. FIGURES Figures should be inserted at the appropriate point in your text. Figures may extend over the two columns up to 17.8 cm (7") if necessary. Black and white photographs (not Polaroid prints) may be mounted on the camera-ready paper with glue or double-sided tape. A service bureau can make a special print of your black and white photography for printing purposes (optional). To avoid smudges, attach figures by paste or tape applied to their back surfaces only. Each figure should have a figure caption in Times Roman. LANGUAGE, STYLE AND CONTENT The written and spoken language of ISFST2000 is English. Please write for an international audience: * Write in a straightforward style. Use simple sentence structure. Try to avoid long sentences and complex sentence structures. Use semicolons carefully. * Use common and basic vocabulary (e.g., use the word "unusual" rather than the word "arcane"). * Briefly define or explain all technical terms. * Explain all acronyms the first time they are used in your text - e.g., "World Wide Web (WWW)". * Explain local references (e.g., not everyone knows all city names in a particular country). * Explain "insider" comments. Ensure that your whole audience understands any reference whose meaning you do not describe (e.g., do not assume that everyone has used a Macintosh or a particular application). * Explain colloquial language and puns. Understanding phrases like "red herring" requires a cultural knowledge of English. Humor and irony are difficult to translate. * Use unambiguous forms for culturally localized concepts, such as times, dates, currencies and numbers (e.g., "1-5- 98" or "5/1/98" may mean 5 January or 1 May , and "seven o'clock" may mean 7:00 am or 19:00). * Be careful with the use of gender-specific pronouns (he, she) and other gendered words (chairman, manpower, man-months). Use inclusive language (e.g., she or he, s/he, they, chair, staff, staff-hours, person-years) that is gender-neutral. If necessary , you may be able to use "he" and "she" in alternating sentences, so that the two genders occur equally often. ACKNOWLEDGMENTS We thank CHI, PDC and CSCW volunteers who wrote previous versions of this document. REFERENCES 1. Anderson, R.E. Social impacts of computing: Codes of professional ethics. Social Science Computing Review 10, 2 (Winter 1992), 453-469.